RH2 Match Set Antler Mounting Kit

Designed for a pair of shed antlers, the patent pending RH2 is manufactured from high-strength aluminum that has been anodized in a matte black finish. The two ball joint assemblies rotate on all axes allowing your antlers to be displayed in virtually any position. After you find that perfect position, simply tighten the top knurled cap. Your trophy orientation will remain intact and you’ll be able to remove your antlers at any time, show them off, and then dock them back in place. Our clean minimal aesthetic ensures all of the focus will be on your trophy. Note: There is a set screw located on the bottom of the ball joint that can be tightened to ensure maximum security; this feature is optional and not necessary. - Display your son or daughters first set of antlers and change them out as they grow - If you're not into european mounts with the full skull look, you can cut off the antlers and display them - Showcase that buck you harvested as a 5 year old by displaying his match set shed beside his shoulder mount Package includes: - Fully assembled RH2 - Installation instructions - Antler inserts (x2) - 5/16" Brad point drill bit - 3/32” hex wrench - Mounting screws (x2) (antlers not included) Installation Instructions Mount the RH2 bracket to a wall or desired location. Use the included 5/16" bit to drill into the base of the antler. (approximately 1 inch in depth) Place the provided insert into the base of the antler. Place each antler onto the hex stem (attached to the ball). Adjust antler positioning by rotating the ball and tightening the top knurled cap. Step back and enjoy your trophy, knowing that you can remove the antlers at any time. ADDED BENEFITS: | on/off removability | new antlers (insert packs) | toolless updating | just need a charged drill | simplest taxidermy available - mount your antlers in minutes!